Esp32 wearable development board

Despeje
Esp32 wearable development board
Velleman
Número de artículo54215
MarcaVelleman
ModeloVMW101
if !data.Virtual} todavía...piezas op voorraad ¿Necesitas un número mayor? Fecha de envío prevista: Martes 27 Octubre.
Enviado desde  € 12,50 - Hispaania
¡Casi agotado!Solamente3piezas en stock. En ventaEste producto está en oferta € 25,31 . DespejeVenta de stock residual, la oferta se aplica mientras dure el stock.
Vendido por pedazo
€ 19,30
Añadir al carrito

Descripción

Meet the most versatile wearable and ESP32 based development board! It is 100% compatible with Arduino, easy and invisible to wear thanks to the unique thin PCB with 8 x sewable pads. In addition, the PCB has no sharp edges and therefore does not prick. Also 4 of the pads are capacitively touch-sensitive.

As far as versatility is concerned, this small development board (56 x 50 x 7.5 mm) has many functions such as a hall-effect sensor, a temperature sensor and an analog preamplifier with low energy consumption. The best feature is undoubtedly the possibility to connect the board to WiFi and Bluetooth. Need ideas? Connect the board to our BrightDot portable LED collection and have them respond to text or social messages, magnets, sounds, time, temperature, ...!

Thanks to the JST connector, you can easily connect this wearable to a battery and you do not have to worry about high consumption. The board is equipped with a deep sleep mode to keep consumption to a minimum when you do not need it. In addition, this thin board is at least 10 times faster than an Arduino Uno thanks to the very high clock speed of 240 MHz.

Characteristics
    With wifi and Bluetooth®
    8 x seamable pads
        4 x power pads
        4 x capacitive touch-sensitive pads
    1 x built-in orange LED
    Hall sensor
    Temperature sensor
    Analog preamplifier with very low power consumption
    Integrated Lipo charger
    Reset button
    2 x 8-bit DACs
    Ultra thin PCB
    Compatible with Arduino®
    Compatible with all BrightDot wearable ledboards
    Based on ESP32
    SPI, I²S, I²C and UART interfaces
    The LED PWM, UART, I2C, I2S and SPI functions are configurable as GPIO
    12-bit SAR A / D converter
    PWM LED driver (max. 16 channels)
    Deep sleep mode for low energy consumption

Specifications
    GPIO: 17
    Processor:
        CPU: Xtensa dual-core (or single-core) 32-bit LX6 microprocessor, operates on 160 or 240 MHz and performs up to 600 DMIPS
        Ultra low power (ULP) co-processor
    Memory:
        520 Kb SRAM
        448 Kb ROM
    Wireless:
        Wifi: 802.11 b / g / n
        Bluetooth®: v4.2 BR / EDR and BLE
    Power consumption:
        Max. power consumption: 300 mA
        Deep sleep power consumption: 10 μA
        Max battery input voltage: 6 V
        Max battery charge current: 450 mA
    Dimensions: 56 x 50 x 7.5 mm (W x L x H)

Pregunta y respuesta

Comentarios

Esp32 wearable development board Haz clic en una estrella para dejar tu opinión.

Otros clientes también compraron o vieron

visto por última vez