Automation HAT

Automation HAT
Pimoroni
Puntuación de revisión
5.0 / 5.0
Número de artículo54640
MarcaPimoroni
ModeloPIM213
... Piezas en stock mientras dure la oferta ¿Necesitas un número mayor? Fecha de envío prevista: Martes 26 Enero.
Enviado desde  € 12,50 - Hispaania
¡Casi agotado!Solamente 4 piezas en stock.
Vendido por pedazo
€ 35,25
Añadir al carrito
  • Compre 10 piezas por € 33,90 por pedazo 4% de descuento
  • Compre 25 piezas por € 32,50 por pedazo 8% de descuento
  • Compre 50 piezas por € 31,15 por pedazo 12% de descuento
  • Compre 100 piezas por € 29,80 por pedazo 15% de descuento
  • Compre 500 piezas por € 28,40 por pedazo 19% de descuento

Descripción

Take control of and monitor your world with our ultimate jack-of-all-trades Raspberry Pi HAT! We've pulled together a great set of features into this home monitoring and automation controller. With relays, analog channels, powered outputs, and buffered inputs (all 24V tolerant) you can now hook up a plethora of goodies to your Raspberry Pi all at once.

Better still each channel has an indicator LEDs which means at a glance you can see what's happening with your setup. Even the analog channels have dimming LEDs that allow you to see the value they are currently sensing - swish!

Ideal for smart home and automation projects, giving your greenhouse intelligent sprinklers, or scheduling your fish feeding!

Features
  • 3 x 24V @ 2A relays (NC and NO terminals)
  • 3 x 12-bit ADC @ 0-24V (±2% accuracy)
  • 3 x 24V tolerant buffered inputs
  • 3 x 24V tolerant sinking outputs
  • 15 x channel indicator LEDs
  • 1 x 12-bit ADC @ 0-3.3V
  • 3.5mm screw terminals
  • Power, Comms, and Warn! LED indicators
  • SPI, TX (#14), RX (#15), #25 pins broken out
  • Automation HAT pinout
  • Compatible with Raspberry Pi 3B+, 3, 2, B+, A+, Zero, and Zero W
  • Python library
  • Schematic
  • Comes fully assembled (broken out pins require soldering)
 
Notes
  • We recommend you use a set of brass M2.5 standoffs with Automation HAT to avoid pins contacting the HDMI port if the HAT is pushed down
  • Loads for the buffered outputs should be switched on the ground side, i.e. 12/24V (from supply) -> load -> output terminal -> ground (from supply)
  • The relays can tolerate up to 2A each and should be switched on the high side
  • The sinking outputs can sink a maximum 500mA total across the 3 outputs, so if you use a single channel you can sink the whole 500mA across it.
  • The accuracy of the ADC is ±2%.
  • Do not use to switch mains voltages!

Pregunta y respuesta

Comentarios

Los países bajos
5 Estrellas
Bien y bien embalado, buen descuento
Colocado en 



Automation HAT Haz clic en una estrella para dejar tu opinión.

Otros clientes también compraron o vieron

visto por última vez